Thromboelastogram (TEG) (2024)

  • Chris Nickson

Reviewed and revised by Hamish Lala and Chris Nickson

OVERVIEW

Thromboelastography (TEG) is a viscoelastic hemostatic assay that measures the global viscoelastic properties of whole blood clot formation under low shear stress

  • TEG shows the interaction of platelets with the coagulation cascade (aggregation, clot strengthening, fibrin cross-linking and fibrinolysis)
  • does not necessarily correlatewith blood tests such as INR, APTT and platelet count (which are often poorer predictors of bleeding and thrombosis)
  • This page describes TEG® predominantly,ROTEM® is the alternative viscoelastic hemostatic assay that is widely available commercially

METHOD

  • TEG®measures the physical properties of the clot in whole blood via a pin suspended in a cup (heated to 37C) from a torsion wire connected with a mechanical-electrical transducer
  • Theelasticity and strength of the developing clot changes the rotation of the pin, which is convertedinto electrical signals that a computer uses to create graphical and numerical output
  • point of care test (quick, takes around 30min)
  • can be repeated easily and compared and contrasted
  • requires calibration 2-3 times daily
  • should be performed by trained personnel
  • susceptible to technical variations
  • kaolin and more recently kaolin + tissue factor (TF) (RapidTEG®) are used as activators, NATEM (TEG® using native whole blood) is slower
  • other tests are available including functional fibrinogen, a measure of fibrin-based clot function, and Multiplate which evaluates platelet function

TEG6s (Haemonetics)

  • This newer machine no longer uses the ‘pin-in-cup’ technique (as did its TEG5000 predecessor)
  • It uses ‘resonance’ where blood is exposed to a fixed vibration frequency range and the detector measures the vertical motion of blood meniscus under LED illumination and transforms that movement into tracing of clot dynamics
  • With pre-prepared cartridges, there is no longer any pipetting required!

USE

Indications

  • prediction of need for transfusion (maximum amplitude (MA) is a useful predictor in trauma)
  • guide transfusion strategy

Studies show cost-effectiveness and reduction in blood products in:

  • liver transplantation
  • cardiac surgery

Maybe useful in:

  • trauma (reduction in blood product use and mortality in cohort studies)
  • obstetrics (some data to show that it may decrease transfusion rates; this is controversial)
  • early detection of dilutional coagulopathy

Hard to interpret in certain situations:

  • low molecular weight heparin (LMWH)
  • aspirin
  • post cardiac bypass
  • fibrinolysis
  • hypercoagulability

NORMAL TEG

Specific parameters represent the 3 phases of the cell-based model of haemostasis:initiation,amplification, andpropagation

  • R value = reaction time (s)
    • time of latency from start of test to initial fibrin formation(amplitude of 2mm)
    • initiation phase
    • dependent on clotting factors
  • K = kinetics (s)
    • time taken to achieve a certain level of clot strength (amplitude of 20mm)
    • amplification phase
    • dependent on fibrinogen
  • alpha = angle (slope of line between R and K)
    • measures the speed at which fibrin build up and cross-linking takes place, hence assesses the rate of clot formation
    • “thrombin burst” / propagation phase
    • dependent on fibrinogen
  • TMA = time to maximum amplitude(s)
  • MA = maximum amplitude (mm)
    • represents the ultimate strength of the fibrin clot; i.e. overall stability of the clot
    • dependent on platelets (80%) and fibrin (20%) interacting via GPIIb/IIIa
  • A30 or LY30 = amplitude at 30 minutes
    • percentage decrease in amplitude at 30 minutes post-MA
    • fibrinolysis phase
  • CLT = clot lysis time (s)

Approximate normal values (kaolin activated TEG, values differ if native blood used, and between types of assay)

  • R:4-8 min
  • K:1-4 min
  • α-Angle:47-74°
  • MA:55-73mm
  • LY 30%:0-8%

Corresponding terminology for ROTEM

ROTEMTEG
Clotting time (CT)R value (reaction time)
α angle and clot formation time (CFT)K value and α angle
Maximum clot firmness (MCF)Maximum amplitude (MA)
Clot lysis (CL)LY30

IMPORTANT PATTERNS

Thromboelastogram (TEG) (3)

TEG AS A GUIDE TO TREATMENT

  • Increased R time => FFP
  • Decreased alpha angle => cryoprecipitate
  • Decreased MA => platelets (consider DDAVP)
  • Fibrinolysis => tranexamic acid (or aprotinin or aminocaproic acid)

Or use this handy guide (-:

Thromboelastogram (TEG) (4)

TEG®VERSUS ROTEM®

Comparison

  • Two commercial types of viscoelastic testsare available: thromboelastography =TEG® (developed in 1948, now produced in theUSA) and rotational thromboelastogram = ROTEM® (from Germany)
  • differences in diagnostic nomenclature for identical parameters between the two
  • TEG® operates by moving a cup in a limited arc (±4°45′ every 5s) filled with sample that engages a pin/wire transduction system as clot formation occur
  • ROTEM® has an immobile cup wherein the pin/wire transduction system slowly oscillates (±4°45′every 6s)
  • results are not directly comparable as different coagulation activators are used
  • ROTEM® is more resistant to mechanical shock, which may be an advantage in the clinical setting

Equivalent variables forROTEM®

  • Clotting time (CT) =R value (reaction time)
  • α angle and clot formation time (CFT) =K value and α angle
  • Maximum clot firmness (MCF) =Maximum amplitude (MA)
  • Clot lysis (CL) =LY30

COMPARISON WITH PLASMA CLOTTING TESTS

Pros of viscoelastic hemostatic assays

  • assessment of global haemostatic potential provides more information than time to fibrin formation
  • can readily differentiate a coagulopathy due to low fibrinogen from one due to thrombocytopenia
  • point-of-care (POC) device with rapidturnaround times so thatmany results available within 5–10 min of starting the test

Cons of viscoelastic hemostatic assays

  • variable availability and user familiarity
  • marked inter-operator variability and poor precision
    • UK NEQAS data suggests coefficients of variance ranging from7.1% to 39.9% for TEG® and 7.0% to 83.6% for ROTEM®
  • may require specialist staff to perform

EVIDENCE

  • Cochrane review (2015)of the use of TEG and ROTEM in traumatic bleeding advised that they should be used for research only, due to a lack of evidence for the accuracy of the assays.

References and Links

CCC Transfusion Series

Journal articles

FOAM and web resources

[cite]

Thromboelastogram (TEG) (5)

Critical Care

Compendium

…more CCC

Chris Nickson

Chris is an Intensivist and ECMO specialist at theAlfred ICU in Melbourne. He is also a Clinical Adjunct Associate Professor at Monash University.He is a co-founder of theAustralia and New Zealand Clinician Educator Network(ANZCEN) and is the Lead for theANZCEN Clinician Educator Incubatorprogramme. He is on the Board of Directors for theIntensive Care Foundationand is a First Part Examiner for theCollege of Intensive Care Medicine. He is an internationally recognised Clinician Educator with a passion for helping clinicians learn and for improving the clinical performance of individuals and collectives.

After finishing his medical degree at the University of Auckland, he continued post-graduate training in New Zealand as well as Australia’s Northern Territory, Perth and Melbourne. He has completed fellowship training in both intensive care medicine and emergency medicine, as well as post-graduate training in biochemistry, clinical toxicology, clinical epidemiology, and health professional education.

He is actively involved in in using translational simulation to improve patient care and the design of processes and systems at Alfred Health. He coordinates the Alfred ICU’s education and simulation programmes and runs the unit’s educationwebsite,INTENSIVE. He created the ‘Critically Ill Airway’ course and teaches on numerous courses around the world. He is one of the founders of theFOAMmovement (Free Open-Access Medical education) and is co-creator oflitfl.com,theRAGE podcast, theResuscitologycourse, and theSMACCconference.

His one great achievement is being the father of three amazing children.

OnTwitter, he is@precordialthump.

| INTENSIVE | RAGE | Resuscitology | SMACC

3 Comments

  1. Brilliant article
    Explaining this complex topic so simply
    I loved it.
    Thank you

  2. Are there any additional / newer technology(ies) available today?

  3. […] Life in the Fast Lane on POC coagulation testing […]

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Thromboelastogram (TEG) (2024)

FAQs

What is TEG Thromboelastogram used for? ›

TEG is a non-invasive test that quantitatively measures the ability of whole blood to form a clot. The principle of this in vitro test is to detect and quantify dynamic changes of the viscoelastic properties of a blood sample during clotting under low shear stress.

What is the difference between TEG and PT aPTT? ›

The aPTT and PT tests are about 5% of clot formation, while TEG looks at the dynamics of clot formation from clot initiation, propagation, and clot lysis. This gives you the whole blood clotting picture,” Dr. Lim explained.

What is the difference between TEG and Coag? ›

More common tests of blood coagulation include prothrombin time (PT) and partial thromboplastin time (aPTT) which measure coagulation factor function, but TEG also can assess platelet function, clot strength, and fibrinolysis which these other tests cannot.

What are the disadvantages of TEG? ›

However, the major limitation of TEG is that it fails to assess the procoagulant (thrombin-generating) and fibrinolysis-inhibiting (PAI-1; TAFI) properties of platelets.

How long does a TEG test take? ›

Each TEG run generally takes 30 minutes to an hour to complete and only a few cases can run simultaneously, unlike conventional lab coagulation testing. Therefore, optimization of TEG use is an important concern in providing appropriate patient laboratory testing.

What is TEG in sepsis? ›

Thromboelastography (TEG) is regularly used for monitoring abnormalities of the coagulation system in patients with sepsis.

What is TEG in cardiac surgery? ›

Thromboelastography (TEG) to direct transfusion management during and immediately after cardiothoracic surgery reduced blood product usage in our institution.

What is a TEG for GI bleed? ›

Thromboelastography (TEG) provides a more comprehensive global coagulation assessment than routine tests (international normalized ratio [INR] and platelet [PLT] count), and its use may avoid unnecessary blood component transfusion in patients with advanced cirrhosis and significant coagulopathy who have nonvariceal ...

What is a normal TEG value? ›

For healthy volunteers, the normal ranges of TEG parameters were as follows: R, 4.3–9.3 min; K, 1.2–3.2 min; α, 50.2–71.2°; MA, 54.1–71.3 mm; LY30: 0%–2.2%; CI, −3.8–2.4.

What is the purpose of TEG? ›

Thromboelastography (TEG), invented in 1948, is an assay that detects the contribution of both cellular and plasma components of hemostasis [1]. It provides global information about fibrin formation, platelet activation, and clot retraction in real-time.

What are the advantages of TEG? ›

In addition, TEGs are position-independent, have a long working life and are ideal for bulk and compact applications. Furthermore, Thermoelectric generators have been found as a viable solution for direct generation of electricity from waste heat in industrial processes.

What does TEG solution do? ›

TEG is used by the oil and gas industry to "dehydrate" natural gas. It may also be used to dehydrate other gases, including CO2, H2S, and other oxygenated gases.

Where is TEG used? ›

The excellent humectant (hygroscopicity) property of TEG also makes it ideal for use in fibres treatment, paper, adhesives, printing inks, leather and cellophane. In the oil and gas industry, the main use is to dehydrate gases.

What are the new uses for thromboelastography? ›

Thromboelastography-guided therapy improves patient blood management and certain clinical outcomes in elective cardiac and liver surgery and emergency resuscitation: a systematic review and analysis. J Thromb Haemost. 2019;17:984-994.

Top Articles
Latest Posts
Article information

Author: Msgr. Benton Quitzon

Last Updated:

Views: 5714

Rating: 4.2 / 5 (43 voted)

Reviews: 90% of readers found this page helpful

Author information

Name: Msgr. Benton Quitzon

Birthday: 2001-08-13

Address: 96487 Kris Cliff, Teresiafurt, WI 95201

Phone: +9418513585781

Job: Senior Designer

Hobby: Calligraphy, Rowing, Vacation, Geocaching, Web surfing, Electronics, Electronics

Introduction: My name is Msgr. Benton Quitzon, I am a comfortable, charming, thankful, happy, adventurous, handsome, precious person who loves writing and wants to share my knowledge and understanding with you.